SAFETY
SAFETY
Shoulder Strap
position that places the shoulder strap level with, or below the top of the child’s shoulder and feed the shoulder harness under the correct loop. To adjust harness slot unhook
PLATFORM - Safety Belt
• Secure the stand feature safety belt behind child and engate buckle (Fig. 22). This is the same safety belt you use to secure the rear
Waist Strap
Squeeze
Adjust for a snug fit
the shoulder strap from the crotch buckle. (Fig. 17) Feed the shoulder strap through the harness spread slots. You can access these slots from the rear of the seat. Feed shoulder strap through appropriate slot and reattach shoulder strap to crotch buckle.
infant car seat.
Crotch Strap
Fig. 18
Fig. 19
Fig. 20
•Carefully place the child in the stroller seat and bring the safety harness around the child’s waist and over the shoulders. Place the crotch strap and between the child’s legs. Insert the male end of each shoulder / waist belt into the buckle on the crotch strap. Tighten the harness to be snug around the child’s waist and over the child’s shoulders. (Fig.18)
•To release, apply pressure to both sides of each male clip until the clip is released. (Fig. 19) This process requires a moderate amount of effort so as to prevent an accidental release by your child.
NOTE: Buckles may be hard to release when 1st used.
TRAVEL SYSTEM - Safety Belt
• Strap the safety belt over the infant car seat through the seat belt slots on the infant car seat, connect the buckles together (Fig. 20). The safety belts for the infant car seat is located in small pockets on outer sides of seat pads. Tighten the strap so the infant car seat fits snug and can't move.
IT IS VERY IMPORTANT THAT THE INFANT CAR SEAT STRAP IS ALWAYS TIGHTLY FASTENED AROUND THE INFANT CAR SEAT.
TO RECLINE SEAT | Fig. 22 |
FRONT SEAT |
|
The front seat has a two position recline. To |
|
recline the seat, rotate the recline bar and press |
|
backward on the seat back. (Fig. 23) To place the |
|
seat in the upright position, press upward on the |
|
seat back while rotating the recline bar. |
|
WARNING: The upright | Fig. 23 |
position should be used only for a |
|
child that is at least 6 months old. |
|
TO ATTACH INFANT CAR SEAT To attach Baby Trend infant car seats (Fig. 24), rotate child trays to the vertical postion first. See rotate child tray for more details.
WARNING: Avoid serious | Fig. 24 |
| |
injury from falling, ALWAYS use |
|
the safety belt to secure the infant |
|
car seat. |
|
Recline the front seat back. Postion the infant car |
|
seat, facing toward the rear of the stroller, so the |
|
seat shell goes into the front child tray and latches |
|
into place. (Fig. 25) |
|
Check that the infant car seat is firmly locked onto |
|
7 | Fig. 21 |
Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved. |
JUMP SEAT - 3-Point Harness
• Secure the child with the jump seat
the child tray and STRAP THE SAFETY BELT |
|
OVER THE CAR SEAT through the seat belt |
|
slots on the infant car seat, connect the buckles |
|
together. (Fig. 26) Tighten the strap so the infant | Fig. 25 |
| |
| Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved. 8 |