Baby Trend 2.1 manual Assembly Safety, Brakes, Canopy, Platform, To Secure the Child

Page 4

ASSEMBLY

SAFETY

red button

Fig. 9

Underside of the child tray

release lever

Fig. 10

the child tray must be rotated to the vertical position. Press red buttons on both sides of the child tray to rotate down 90 degrees. (Fig. 9)

To remove the child tray:

Pull both release levers located on the underside of each side of the tray and lift upward. (Fig. 10)

CUP HOLDER (sold separately)

This is an optional accessory item that can be purchased online at www.babytrend.com. The removeable child tray can be replaced with 2 individual cup holders. It is ideal for an older child.

To attach the cup holder:

Push the cup holder downward and onto each side of the front armrests until it snaps into place. (Fig. 11)

it rests in place on the axle rod. Once in place release both locking clips. (Fig. 14)

Before placing your children in the stroller, please follow the instructions below.

WARNING: Always set brakes when the stroller is not being pushed so that the stroller will not roll away. NEVER leave stroller unattended on a hill or incline as the stroller may slide down the hill.

BRAKES

To engage brakes, apply light downward pressure to the brake lever located on each rear wheel. The stroller may require slight forward or rearward movement in order to line up the teeth on the brake with each wheel brake cluster. (Fig. 15) Check that the stroller will not move and that both brakes are properly applied. To release, gently lift up on the brake lever. (Fig. 16)

Fig. 14

Fig. 15

Fig. 11

Fig. 12

Fig. 13

CANOPY

To attach the canopy:

Line up the male fittings on the canopy with the slots on the armrest and push both fittings downward until snapped into place. (Fig.12) To open the canopy, push forward on the front edge of the canopy while holding the rear of canopy in place. To fold the canopy, push forward on the front edge.

To remove the canopy:

Press the snap button under the armrest and pull to release the fitting from the slot. Repeat for the other side.

PLATFORM

To attach platform:

Squeeze both locking clips with both hands while holding the platform vertically (Fig. 13). Then slowly rotate the platform downward until

Fig. 16

TO SECURE THE CHILD

WARNING: Avoid serious injury from falling or sliding out. Always use the safety harness.

STRANGULATION

HAZARD: Child can strangle in loose straps. Never leave child in seat when straps are loose or undone.

TANDEM STOLLER - 5-Point Harness

 

• The shoulder straps of the 5-point harness

 

has 2 attachment positions. Select the loop

Fig. 17

5

Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.

Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.

6

Image 4
Contents Tag-A-LongTandem Stroller Obtain replacement parts PartsAssembly Assembly Safety BrakesCanopy PlatformPlatform Safety Belt Travel System Safety BeltTo Recline Seat Front SeatFold Jump SeatTo Fold Stroller Seat PAD