10. The Walking Kit
The assembled Walker (Ready Chassis + Walking Kit)
Supplied as standard
Drawbars with hip strap, additional
Safety instructions for use as Walker
•Please make sure you read the safety instructions in the “Safety” section at the beginning of this Owner’s Manual.
•Before each journey check that all components are properly fi tted, particularly the wheels and the tow bars.
•Always make sure that the security pin of the tow bars are properly installed, so as to prevent the carrier from accidentally separating from the bars.
•Make sure the length of the tow bars is adjusted correctly, to ensure that your poles cannot come into contact with the carrier.
•Be mindful of the space needed due to the width and length of the carrier. Take care in oncoming traffi c on narrow paths!
•Please remember that controlling a fully laden walker requires experience and good physical fi tness.
•Particular care is needed on slopes, uneven terrain and when stopping.
•First take the walker for a practice run without children, but with the maximum load. Perform the practice run on terrain that is more diffi cult to cover than that which you want to travel later with children.
Fitting the drawbars to the carrier
Identical for all models.
Insert each drawbar into the VersaWing 2.0 until the vertical holes in the arms and VersaWing 2.0 are aligned with each other. The drawbars should now, at the back in the slot of the VersaWing 2.0, protrude about 2 cm / 3/4“ over the plastic edge.
36