Chariot Carriers Corsaire XL, Captain XL manual Length adjustment of the drawbars

Now secure the drawbars by inserting the security pin from above through the vertical hole in the arm and VersaWing 2.0 until it stops. Lock the security pin by looping the spring clip over the pins end that protrudes underneath the VersaWing 2.0.

Putting on the waist belt

Always put the waist belt on so that the padded area is at the back and the strap with its side-release buckle is at the front. Always close the buckle with care!

DANGER

Always make sure that the security pins of the drawbars are properly inserted to prevent the carrier from accidentally running away. You run the risk of an accident!

Adjust the 2 straps on either side of the buckle to that it is a tight fi t around your hips, and so that the buckle is centered.

TIP

The holes in the drawbars are larger than the security pins, so that the arms can rotate slightly around their longitudinal axes (in order to adapt to narrow or wide hips, and single and double width carriers).

Length adjustment of the drawbars

The drawbars are adjustable for length. To do this, withdraw the security pin which connects the two drawbar tubes.

Move both tubes towards each other until the desired holes in both tubes align with each other.

Reinsert the security pin, pushing it in until it goes no further.

DANGER

Always make sure that the security pins which connect both tubes of the drawbar are properly inserted in to prevent the carrier from accidentally running away. You run the risk of an accident!

DANGER

Always make sure the buckle on the strap is securely closed and the strap fi ts tightly. If this is not done, the Carrier might get separated from you and run away. You run the risk of an accident!

If required, the waist belt can be adjusted for larger and smaller hips. To do this, undo both attachment screws and reinstall them into the appropriate grommets. When refi tting the screws, always use the additional self-locking nuts supplied.

DANGER

Once self-locking nuts have been loosened they cannot be reused. Once they have been loosened, they lose their se- curing function, and this can lead to unexpected loosening of the screw connection with potentially serious consequences.

37