Philips SCF260/33 manual ES Gracias por elegir Philips Avent, Troubleshooting Guide, Contenido

The temperature of warmed food depends on the consistency of the food. Philips

AVENT recommends that, ideally, pureed food only should be heated with this

Food is not

warmer. If you find that thicker food is not warm enough at the end of the

warming cycle, fill the warmer with an additional 1oz/30ml of water. On step

warm enough

4 and 5, choose the food from room temperature mode and program the

warmer at the 1oz/30ml option. Before feeding your baby, stir the food.

Always check food temperature before feeding.

If you find that milk is not warm enough at the end of a warming cycle, fill the

warmer with an additional 1oz/30ml of water. On step 4 and 5, choose the milk

Milk is not

from room temperature mode and program the warmer at the 1oz/30ml option.

warm enough

Before feeding your baby, shake the bottle, nurser or storage container gently

and check the temperature of the milk by sprinkling a few drops on the back

of your hand.

Display will not

Check that the lid is closed correctly. Check that the warmer is plugged

illuminate / Warmer

in correctly. Then hold the Power/Mode Selection Button for 3 seconds.

will not turn on

• If the milk, room temperature and oz/ml symbols are flashing, then the lid

has not been closed correctly.

• If all volume symbols are flashing, and the warmer beeps intermittently for

Symbols on the

30 seconds then the cycle is complete. Follow Step 8 onwards to remove the

bottle or container from the warmer.

display are flashing

• If all mode and starting temperature symbols are flashing, then the unit

requires de-scaling. See section ‘Care of your Digital Bottle and Baby Food Warmer’

on page 5. To acknowledge the de-scale warning, press and hold the Power/

Mode Selection or Volume Selection/Start Button for 3 seconds. If you do not

wish to de-scale, please be aware that this may cause irreparable damage.

• If oz/ml symbols flash, and the warmer beeps twice, insufficient water has been

placed in the warmer. Unplug the warmer, discard the milk or food and empty

The warmer

any remaining water. Be careful as the warmer is hot. Follow instructions from

Step 1 onwards.

is beeping

• If all volume symbols are flashing, and the warmer beeps intermittently for

30 seconds then the cycle is complete. Follow Step 8 onwards to remove the

bottle or container from the warmer.

To stop the

Press the Power/Mode Selection Button and the warmer will beep and return to

warming cycle

default settings.

To start the

Once the correct mode, starting temperature and volume have been selected,

warming cycle

press and hold the Volume Selection/Start Button until the warmer beeps.

If the lid is opened at any time during the warming cycle, the lights on the display

If the lid is opened

panel will flash and the warmer will stop and return to default settings. In order to

reset the warmer after the lid has been opened, empty out any residual water, then

during warming cycle

follow instructions for use from step 1 onwards. Since this could occur at any stage

of the warming cycle, milk or food should be discarded for safety reasons.

Difficulty setting the

The maximum volume that may be selected when warming food from frozen

appropriate amount of

is 8oz/240ml.

frozen food