Vector VEC012 instruction manual Never Attempt to JUMP-START or Charge a Frozen Battery

Page 4

90527010 VEC012 EN SP.qxp:VEC012_ManualEN_090407 9/11/09 8:17 AM Page 3

This equipment employs parts (switches, relays, etc.) that produce arcs or sparks. Therefore, if used in a garage or enclosed area, the unit MUST be placed not less than 18 inches above the floor.

THIS UNIT IS NOT FOR USE BY CHILDREN AND SHOULD ONLY BE OPERATED BY ADULTS.

CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:

Pull cord by plug rather than cord when disconnecting the 120V AC Charging Adapter from the unit.

NEVER ATTEMPT TO JUMP-START OR CHARGE A FROZEN BATTERY.

To recharge this unit, use only the supplied AC Charging Adapter.

Vehicles that have on-board computerized systems may be damaged if vehicle battery is jump-started. Before jump-starting, read the vehicle’s owner’s manual to confirm that external-starting assistance

is suitable.

When working with lead acid batteries, always make sure immediate assistance is available in case of accident or emergency.

Always have protective eyewear when using this product: contact with battery acid may cause blindness and/or severe burns. Be aware of first aid procedures in case of accidental contact with battery acid.

Have plenty of fresh water and soap nearby in case battery acid contacts skin.

If battery acid contacts skin or clothing, wash immediately with soap and water for at least 10 minutes and get medical attention immediately.

Never smoke or allow a spark or flame in vicinity of vehicle battery, engine or power station

Remove personal metal items such as rings, bracelets, necklaces and watches when working with a lead acid battery. A lead acid battery can produce a short circuit current high enough to weld a ring, or similar metal object, to skin, causing a severe burn.

Do not wear vinyl clothing when jump-starting a vehicle when jump-starting a vehicle, friction can cause dangerous static-electrical sparks.

Jump-start procedures should only be performed in a safe, dry, well-ventilated area.

Always store battery clamps when not in use. Never touch battery clamps together. This can cause dangerous sparks, power arcing and/or explosion.

When using this unit close to the vehicle’s battery and engine, stand the unit on a flat, stable surface, and be sure to keep all clamps, cords, clothing and body parts away from moving vehicle parts.

Never allow RED and BLACK clamps to touch each other or another common metal conductor — this could cause damage to the unit and/or create a sparking/explosion hazard.

a)For negative-grounded systems, connect the POSITIVE (RED) clamp to the POSITIVE ungrounded battery post and the NEGATIVE (BLACK) clamp to the vehicle chassis or engine block away from the battery. Do not connect the clamp to the carburetor, fuel lines or sheet-metal body parts. Connect to a heavy gauge metal part of the frame or engine block.

b)For positive-grounded systems, connect the NEGATIVE (BLACK) clamp to the NEGATIVE ungrounded battery post and the POSITIVE (RED) clamp to the vehicle chassis or engine block away from the battery. Do not connect the clamp to the carburetor, fuel lines or sheet-metal body parts. Connect to a heavy gauge metal part of the frame or engine block.

If the connections to the battery’s POSITIVE and NEGATIVE terminals are incorrect, the Reverse Polarity Indicator will light (red) and the unit will sound a beep. Disconnect clamps and reconnect to battery with correct polarity.

Always disconnect the NEGATIVE (BLACK) jumper cable first, followed by the POSITIVE (RED) jumper cable, except for positive grounded systems.

Do not expose battery to fire or intense heat since it may explode. Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting (shorting can result in injury or fire).

Place this unit as far away from the battery as cables permit.

Never allow battery acid to come in contact with this unit.

Do not operate this unit in a closed area or restrict ventilation in any way.

FIRST AID – SKIN: If battery acid comes in contact with skin, rinse immediately with water, then wash thoroughly with soap and water. If redness, pain, or irritation occurs, seek immediate medical attention.

EYES: If battery acid comes in contact with eyes, flush eyes immediately, for a minimum of 15 minutes and seek immediate medical attention.

3

Image 4
Contents START-IT450 AMP JUMP-START System General Safety Warnings and Instructions for ALL Appliances Read ALL InstructionsSafety Guidelines / Definitions Never Attempt to JUMP-START or Charge a Frozen Battery Features IntroductionControls and Indicators Viewing Battery Charge StatusCHARGING/RECHARGING Volt AC Charging MethodCharging/Recharging Accessories Care and MaintenanceJUMP-STARTER Service Information Battery Replacement/Disposal Battery DisposalFull TWO-YEAR Home USE Warranty SpecificationsConserve Este Manual Para Futuras Consultas LEA Todas LAS Instrucciones Advertencia Riesgo DE Descarga Eléctrica Voltios Longitud total del cable en piesAdvertencia Riesgo DE Gases Explosivos Introducción Advertencia Para Reducir EL Riesgo DE LesionesControles e indicadores CaracterísticasCARGA/RECARGAR Estado de la carga de la batería de la visión Método de carga de la CA de 120 voltiosPuente Auxiliar DE Arranque Cuidado Y Mantenimiento AccesoriosEliminación de la batería Garantía Completa DE DOS Años Para USO EN EL HogarEspecificaciones