![](/images/new-backgrounds/1217189/21718917x1.webp)
Replacing the lamp in your Dumbo Pylon
Your Pylon is illuminated by one
part no.
1.Lift the support arm out of the tubes at the top of the pylon. Also, remove any screws securing the base to your layout.
2.Remove the four base screws from the underside of the base with a small
3.Locate the lamp in its small, black fixture. Carefully pull the lamp straight up and out of the socket. Refer to the Figure 6 on page 11 for the lamp location.
4.Install the replacement lamp. Line up the bottom of the bulb with the socket and carefully push the lamp down into place.
5.Reassemble the Pylon, following these steps in reverse order.
9