Disney 72-4131-250 owner manual Operating your Dumbo Pylon with TrainMaster Command Control

Operating your Dumbo Pylon with TrainMaster Command Control

You may choose to wire your accessory with an SC-2 Switch and Accessory Controller (available separately, 6-22980) or the Accessory Switch Controller (available separately,

6-14182). Refer to these manuals for additional information.

SC-2 wiring and operation

Three wires (not included) are needed to connect your Pylon to the SC-2 and a separate accessory transformer. We recommend using 22 gauge wire. Refer to Figure 3.

1.Attach one wire to the transformer Common/Ground/U terminal and connect it to the accessory COMM (common) position on the SC-2.

2.Connect one of the Pylon terminals to the accessory ON/OFF toggle position on the SC-2.

3.Finally, connect the remaining Pylon terminal to the transformer Power/A terminal. Use the AUX2 button on your CAB-1 Remote Controller to toggle the Pylon ON and OFF.

Pylon
	ACC1	ACC1
	ACC2	ACC2
POWER	Common/Ground/U
SUPPLY
	Power/A

Figure 3. Wiring for Command operation with an SC-2

7