Fisher-Price M8126b-0920 Back to wake him up, On the dinosaur and charge for 4 hours, Erratically

Page 8

TROUBLESHOOTING GUIDE

Problem

Solution

No sounds/lights/motion

• Dinosaur power is not on. Slide the dinosaur power/

from/on dinosaur

volume switch on.

 

• Dinosaur is asleep. Press the red button on the dinosaur’s

 

back to wake him up.

 

• 9.6V NiMH rechargeable battery pack power is weak.

 

Remove the battery pack from the battery compartment

 

on the dinosaur and charge for 4 hours.

 

• Make sure the dinosaur is upright. The dinosaur will not

 

function on its side.

Lights blink on lower tail

• 9.6V NiMH rechargeable battery pack power is weak.

and/or motion is slow

Remove the battery pack from the dinosaur and charge

and sounds are faint

for 4 hours.

Clicking noise from legs/

• The legs are designed with a clutch if the dinosaur legs or

four lights blink on the

head bump into an obstacle. Simply remove the obstacle

dinosaur’s neck

and/or place the dinosaur in another location. Press the

 

red button on the dinosaur’s back to resume play.

Dinosaur does not react

• Remote control power is not on. Slide the power

to remote control

switch ON.

 

• If L.E.D. on remote control lights when you press a

 

button, power is off on dinosaur. Slide the dinosaur

 

power/volume switch ON.

 

• If L.E.D. on remote control does not light when you press

 

a button, battery power in the remote control is weak.

 

Remove and replace the batteries with three “AA” (LR6)

 

alkaline batteries.

 

• If L.E.D. on remote control lights when you press a

 

button, you may be out of range of the dinosaur. Make

 

sure the remote control is no further than 15 feet from

 

the dinosaur and pointed at the dinosaur.

 

• Bright sunlight or fluorescent light may affect the range of

 

the remote control. Try dimming the light in the room.

Dinosaur’s eyes are closed

• Dinosaur is in sleep mode. Press the red button on the

and there are no sounds

dinosaur’s back.

(but dinosaur and remote

 

control switches are on)

 

Dinosaur operates

• 9.6V NiMH rechargeable battery pack power is weak.

erratically

Remove the battery pack from the dinosaur and charge

 

for 4 hours.

 

• Electronics need to be reset. Slide the power/volume

 

switch on the dinosaur OFF and then back ON again.

9.6V NiMH rechargeable

• It is normal for battery to get warm during charging and is

battery pack feels warm

not reason for concern.

 

 

Image 8
Contents Important Safety Instructions Save These Instructions Consumer Information Assembly Dinosaur Remote ControlBattery Safety Information FCC Statement United States Only Page Ultra Dinosaur Experience Press this button to lower Spike’s headControl switches are on Dinosaur operates Battery pack feels warm Not reason for concernBack to wake him up On the dinosaur and charge for 4 hours