Fisher-Price M8126b-0920 Dinosaur, Remote Control, Battery Safety Information

BATTERY CHARGING AND INSTALLATION

9.6V NiMH

Battery Connector

Charger Connector

•Plug the 9.6V NiMH battery connector into the charger connector.

•Plug the charger into a standard wall outlet. The charger L.E.D. turns red.

Notes: If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”. Use the charger only in a wall outlet. Do not plug the charger into a ceiling outlet. To connect to a supply that is not in the United States, use an adapter (not included and sold separately) with the proper configuration for the power outlet.

•Charge the battery for four hours. When charging is complete, the charger L.E.D. turns green.

•Disconnect the charger connector from the battery connector. Unplug the charger from the wall outlet.

Dinosaur

•Locate the battery compartment on the bottom of the dinosaur.

•Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove the battery compartment door.

•Plug the 9.6V NiMH battery connector into the dinosaur connector.

•Fit the connectors into the back slot in the battery compartment and then place the 9.6V NiMH battery pack on top.

•Replace the battery compartment door and tighten the screw with a Phillips screwdriver.

1.5V x 3

"AA" (LR6)

Remote Control

•Locate the battery compartment door on the bottom of the remote.

•Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove the battery compartment door.

•Insert three “AA” (LR6) alkaline batteries.

Hint: We recommend using alkaline batteries for longer battery life.

•Replace the battery compartment door and tighten the screw with a Phillips screwdriver.

•Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities.

Battery Safety Information

In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:

•Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).

•Insert batteries as indicated inside the battery compartment.

•Remove batteries during long periods of non-use. Always remove exhausted batteries from the product. Dispose of batteries safely. Do not dispose of this product in a fire. The batteries inside may explode or leak.

•Never short-circuit the battery terminals.

•Use only batteries of the same or equivalent type, as recommended.

•Do not charge non-rechargeable batteries.

•Remove rechargeable batteries from the product before charging.

•If removable, rechargeable batteries are used, they are only to be charged under adult supervision.