V I . B A T T E R I E S A N D C H A R G I N G
How do I change a battery?
WARNING! Contact your authourized Pride Provider if you have any questions regarding the batteries in your scooter.
WARNING! Do not replace the batteries while the scooter is occupied.
WARNING! The batteries on your scooter should only be servcied or replaced by an authorized Pride Provider or a qualified technician.
MANDATORY! Battery posts, terminals and related accessories contain lead and lead compounds. Wear goggles and gloves when handling batteries and wash hands after handling.
WARNING! Always use two batteries of the exact same type, chemistry and
1.Remove the seat and the rear shroud. See IX. “Disassembly and Assembly.”
2.Disconnect the battery strap.
3.Disconnect the 2 pin, black and white battery harness from its mating plug. See figure 15 in IX. “Assembly and Disassembly.”
4.Disconnect the battery cables from the battery terminals.
5.Remove the old batteries.
6.Place a the new batteries into the battery wells.
7.Connect the red battery cable to the positive (+) battery terminal for each battery.
8.Connect the black battery cable to the negative
9.Reconnect the 2 pin, black and white battery harness to its mating plugs.
10.Reconnect the battery strap.
11.Reinstall the rear shroud and seat.
NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag and call your authorized Pride Provider for instructions on disposal. Your authorized Pride Provider will also have the necessary information on battery recycling, which is our recommended course of action.
Why do my new batteries seem weak?
We work closely with our battery manufacturer to provide batteries that best suit your scooter’s specific electrical demands. Fresh batteries are shipped fully charged to our customers. During shipping, the batteries may encounter temperature extremes that can influence their initial performance. Heat diminishes the charge on the battery; cold slows the available power and extends the time needed to recharge the battery.
V I . B A T T E R I E S A N D C H A R G I N G
It may take a few days for the temperature of your scooter’s batteries to stabilize and adjust to their new room or ambient temperature.
More importantly, it takes a few charging cycles (partial draining followed by full recharging) to establish the critical chemical balance that is essential to a
Follow these steps to properly break in your scooter’s new batteries for maximum efficiency and service life.
1.Fully recharge any new battery prior to its initial use. This charging cycle brings the battery up to about 88% of its peak performance level.
2.Operate your new scooter in familiar and safe areas. Drive slowly at first, and do not travel too far from your home or familiar surroundings until you have become accustomed to your scooter’s controls and have properly broken in your scooter’s batteries.
3.Fully recharge the batteries. They should be at over 90% of their peak performance level.
4.Operate your scooter again.
5.Fully recharge the batteries again.
6.After four or five charging cycles, the batteries are able to receive a charge of 100% of their peak performance level and are able to last for an extended period of time.
What about public transportation?
If you intend to use public transportation with your scooter, you must contact the transportation provider in ad- vance to determine their specific requirements.
28 | www.pridemobility.com | Legend | Legend | www.pridemobility.com | 29 |