I X . D I S A S S E M B LY A N D A S S E M B LY

I X . D I S A S S E M B LY A N D A S S E M B LY

6.Unplug both black and white 2-pin battery harnesses. See figure 17.

7.Unplug the front-to-rear harness. See figure 18.

WARNING! Failure to unplug both battery harnesses and the front-to-rear harness prior to separating the front and rear sections could result in permanent damage to the scooter.

Figure 17. Battery Harnesses

Figure 18. Front-To-Rear Harness

Toggle Latch Release

1.Push in the toggle latch release button while pulling back the toggle latch. See figure 19.

2.Position the toggle latch buckle over the top of the toggle latch. See figure 20.

3.Lower the tiller to the scooter floorboard.

 

 

 

 

 

 

 

 

TOGGLE

TOGGLE

TOGGLE

 

LATCH

 

 

 

LATCH

 

 

 

 

 

 

BUCKLE

 

 

 

 

 

LATCH

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

RELEASE

 

 

 

 

 

 

 

 

 

 

BUTTON

 

 

 

 

 

 

 

 

Figure 19. Toggle Latch (Latched)

 

 

Figure 20. Toggle Latch (Unlatched)

Frame Separation

1.Push back on the seat post to pivot the scooter’s rear section backwards until the rear section is standing vertically on its rear bumper. See figure 21.

2.Lift the front section up until the lower pegs are no longer in the slots. See figure 22.

3.Carefully move the front section away from the rear section.

Figure 21. Frame Positioning

Figure 22. Separating The Frame Sections

ASSEMBLY

1.Position the front and rear sections of your scooter as showninfigure 23.

2.Align the lower slots of the front section with the cor- responding pegs on the front of the rear section.

WARNING! Position the front-to-rear harness cable so it won’t become pinched between the frame halves

when pivoting the rear section forward. See figure 24.

3.Holding the seat post, slowly pivot the rear section forward until the curved locking brackets are fully con- nected onto the top rear pegs. See figure 24.

4.Raise the tiller.

5.Secure the toggle latch. See figure 19.

!Lower the toggle latch buckle.

!Push back on the toggle latch so it locks into place.

6.Connect the front-to-rear harness and both battery harnesses.

7.Replace the shroud.

8.Replace the seat and secure it into place.

Figure 23. Frame Sections

FRONT-TO-REAR HARNESS

Figure 24. Frame Lockup

36

www.pridemobility.com

Legend

Legend

www.pridemobility.com

37

Page 20
Image 20
Pride Mobility Legend 3, Legend 4 manual Toggle Latch Release, Assembly