Fisher-Price T1828 manual Parts, Assembly

Page 3

Parts

Assembly

IMPORTANT! Please remove all parts from the package and identify them before assembly. Some parts may be packed in the pad.

Toy Bar

Pad

Retainer

Seat Back Tube

 

Retainer

Footrest

Left Base Wire

Base Tube

2 Feet

Right Base Wire

IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Fisher-Price®for replacement parts and instructions if needed. Never substitute parts.

Base Tube

Left Base Wire

1

Right Base Wire

 

Place the base tube on a flat surface.

Position the left and right base wires as shown.

Fit the left base wire and right base wire into the base tube.

M5 x 20 mm Screw – 4

Note: Screw shown actual size. Tighten or loosen all screws with a Phillips screwdriver. Do not over-tighten the screws.

2

Non-skid Surface

Position the feet so the non-skid surface is down.

Fit the feet on the base tube, as shown.

3

Image 3
Contents T1828 To prevent serious injury or death Consumer InformationParts AssemblyAssembly Position the pad above the frame Battery Installation LR20Toy Bar Securing Your Infant Setup and UseTo loosen the restraint belts Soothing UnitCare To tighten the restraint belts