Setup and Use | Care |
| Anchored End | Anchored End |
Free End |
| Free End |
3 | TIGHTEN | LOOSEN |
To tighten the restraint belts:
•Feed the anchored end of the restraint belt up through the buckle to form a loop A . Pull the free end of the restraint belt B .
To loosen the restraint belts:
•Feed the free end of the restraint belt up through the buckle to form a loop A . Enlarge the loop by pulling on the end of the loop toward the buckle. Pull the anchored end of the restraint belt to shorten the free end of the restraint belt B .
•The pad is machine washable. Wash it separately in cold water on the gentle cycle. Do not use bleach. Tumble dry separately on low heat and remove promptly.
•The frame, toy bar and toys may be wiped clean using a mild cleaning solution and damp cloth. Do not immerse the toy bar. Do not use bleach. Do not use harsh or abrasive cleaners. Rinse clean with water to remove residue.
C
B
A
A
Soothing Unit
Power Switch
•Make sure your child is properly secured in the seat.
•Slide the power switch to: 
Vibrations or 
Off.
IMPORTANT! Low battery power causes this product to operate erratically: no vibrations and the product may not turn off. Remove and discard the battery and replace with a new
“D” (LR20) alkaline battery.
• Pull the ring on the toy for music and sounds.
To remove the pad:
•Pull to remove the pad from around the retainers and the soothing unit A .
•Remove the bottom pocket of the pad from the footrest B .
•Lift to remove the pad C .
•To replace the pad, refer to Assembly steps 7 - 9.
Protect the environment by not disposing of this product with household waste (2002/96/EC). Check your local authority for recycling advice and facilities (Europe only).
8