AMX DAS-SIRIUS manual Setting the Jumpers, Audio Controller Internal view

DAS-SIRIUS Tuner Module

FIG. 2 provides orientation for the various internal components that must be accessed to install the Tuner Module and set the Jumpers.

Tuner slots (Top = Position 1, Bottom = Position 2)

Tuner

Modules

20-pin Tuner Ribbon Cable connector

rear panel

Rear-Board Pin Bus

(Controller Jumpers)

Tuner Module Jumpers (located behind ribbon cable connector)

20-pin Tuner

Ribbon Cable

front

FIG. 2 Audio Controller - Internal view

Make sure to discharge all static electricity from your body before touching any components of the Tuner Modules or the Audio Controller. Failure to do so may lead to permanent damage to the Tuner or Controller.

Setting the Jumpers

While Mi-Series and Tango Audio Controllers support 2 Tuner Modules in any combination, this document primarily describes installing the DAS-SIRIUS Tuner Module into Position 2 on the Audio Controller (as TUNER 2), leaving the DAS-AMFM Tuner Module in position 1 (as TUNER 1).

Because of the location of the Jumpers in the Controller and on the Tuner Module, it may be easier to make all jumper settings before installing the Tuner Module in the Controller.

2 DAS-SIRIUS Sirius Tuning Module for Mi-Series Audio Controllers