Fisher-Price 77808, 77807, 77806 manual Voice Recognition Errors Expert Mode

	Voice Recognition Errors (Expert Mode)
Symptom	Diagnosis
You do not hear a	• P.P.T. power has shut-off and power L.E.D. is not lit. Press any
“beep” sound after	Command Button or the P.P.T. Large Cover.
you say the dog’s	• The L.E.D. on the mouthpiece is not pointed toward the
name.	glowing L.E.D. on the dog’s head. Be sure the L.E.D. on the
	mouthpiece is not twisted and is in direct line with the L.E.D.
	on the dog’s head.
	• The P.P.T. did not recognize the voice because it was “too
	soft”. Make sure the microphone is approximately 11/2"- 2"
	from your child’s mouth.
	• Your child did not program the name. Please refer to page 8 to
	program a new name.
	• Your child is not using the same name programmed. Open the
	Program Switch Door on the P.P.T. and slide the Program
	Switch to Trainer 1 or Trainer 2. Press the Name Button and
	check which name is programmed.
	• Your child is not saying the name the same way it was original-
	ly programmed. Open the Program Switch Door on the P.P.T.
	and slide the Program Switch to Trainer 1 or Trainer 2. Press
	the Name Button to hear how the name was programmed.
	• Your child does not need to say the dog’s name in this mode.
	With the Large Cover on the P.P.T. closed, simply press the
	Large Cover, wait for a “beep” sound, release the Large
	Cover and then speak the desired command.
You hear one “beep”	• The P.P.T. did not recognize the voice because it was
sound after you say	“too soft”. Make sure the microphone is approximately
the dog’s name;	11/2"- 2" from your child’s mouth.
but do not hear two	• The L.E.D. on the mouthpiece is not pointed toward the

“beep” sounds	glowing L.E.D. on the dog’s head. Be sure the L.E.D. on the
after you say the
	mouthpiece is not twisted and is in direct line with the L.E.D.
command.
	on the dog’s head.
	• Your child did not program the command. Please refer to page
	10 to program a voice command.
	• Your child is not using the same command programmed. Turn
	dog power off. Open the Program Switch Door on the P.P.T.
	and slide the Program Switch to Trainer 1 or Trainer 2. Press
	the desired Command Button and check what has been
	programmed.
	• Your child is not saying the command the same way it was
	programmed. Turn dog power off. Open the Program Switch
	Door on the P.P.T. and slide the Program Switch to Trainer 1
	or Trainer 2. Press the desired Command Button to hear how
	the command was programmed.
	• Your child did not wait for the “beep” sound before saying the
	command. Be sure to wait for the “beep” sound.
	• Your child waited too long (more than three seconds) after the
	“beep” sound. Make sure your child says the command within
	three seconds after the “beep” sound.

22