Stage 2 - Sit & Play
If you have not used this toy before, and are assembling it for
1 | To change from Stage 1 to Stage 2 | |
• Turn the threaded knobs | ||
| ||
| the leg assemblies from the keyboard. | |
|
•Press the star buttons and remove the two supports from the legs. Now, proceed to step 2.
Support |
Leg |
Star Button |
Large Slot |
2 |
•While pressing the star buttons on a support, fit the end of the support into the large slot in one of the legs, as shown. The support should “snap” in place.
•Repeat this procedure to attach the other support to the remaining leg.
|
| Knob |
3 | Leg Assembly | Leg Assembly |
| ||
|
|
Stage Switch | Mode Switch |
•Slide the stage switch to 
for use with babies sitting up.
•Slide the mode switch to 
. When baby presses a key, part of a song plays with twinkling lights. With each press of a key, the song continues building, a little at a time.
• Slide the mode switch to 
. When baby presses a key, musical scales or chords play as twinkling lights follow along.
Hint: If your child is not actively playing with this toy, it turns off automatically (sleep mode).
• Be sure to slide the stage switch to the off O position when not in use.
•Position the keyboard so it faces up.
•Fit a leg assembly to the side of the keyboard, as shown.
•Turn the knob clockwise to secure the leg assembly to the keyboard. Make sure the knob is fully tightened.
•Repeat this procedure to attach the other leg assembly to the keyboard.
| Tab |
4 | Hanger |
|
• Rotate the hangers up and “snap” them into place.
• Attach the toys to the hangers and tabs as shown. | 5 |
|