Acceptable Vehicle Belt Systems
The following belt systems are acceptable for use with your doll booster seat. You should refer to your vehicle owner’s manual to determine which type of seat belts your vehicle has.
•Lap
•Lap Belts with Automatic Locking Retractor (ALR): The automatic locking retractor will not allow the lap belt to lengthen once it is buckled. Tighten the belt by feeding the belt back into the retractor while pushing down hard on the doll booster.
•Combination Lap/Shoulder Belt with Locking Latch Plate: Once it is buckled, this type of belt has a latch plate that will not allow the lap portion of the belt to loosen. Belt is tightened by pulling hard on the shoulder portion of the vehicle belt while pushing down hard on the doll booster.
•Combination Lap/Shoulder Belt with Sliding Latch Plate: This type of belt has a latch plate that slides freely along the belt. To prevent movement of the lap portion of this type belt, the belt MUST be converted through the use of a Locking Clip, unless your vehicle belt can be converted in another way as described in your vehicle owner’s manual.
To Install the Locking Clip
•Tighten the buckled belt by pushing down hard on the doll booster and pulling hard on the shoulder belt.
•While pushing down on doll booster, pinch the two straps together behind the buckle tongue. Unbuckle the belt without allowing it to slip.
•Connect lap and shoulder belts with locking clip as shown. See Figure 8.
•
Figure 8
Page 6 | Doll or Stuffed Toy Booster Seat Instruction Manual |