Unacceptable Vehicle Belt Systems

DO NOT use any of the following systems to secure the doll booster.

•Lap Belts with Emergency Locking Retractor (ELR): This lap belt stays loose and can move until it locks in a sudden stop or crash.

•Combination Lap/Shoulder Belt with Retractor: Each strap has a retractor at one end and is attached to the latch plate at the other end.

•Passive Restraint-Lap or Shoulder Belt Mounted on Door

•Passive Restraint-Lap Belt with Motorized Shoulder Belt

•Lap Belts Installed Forward of Seat Crease

Installing Doll Booster Seat with LATCH

•Extend LATCH Attachment Strap to its maximum length.

•Place the booster in a front-facing position in the vehicle seat.

•Thread LATCH Attachment Strap through one of the slots on the side of the booster and then out the other side slot. See Figure 9. Make sure strap lays ﬂat and is not twisted.

•Push the connectors through the seat crease slots and hook them to vehicle lower anchors. See Figure 10. Pull ﬁrmly on connectors to be sure they are attached.

•Tighten LATCH by pushing down hard on booster and pulling the adjustment belt.

•NEVER put two LATCH Attachment Strap connectors on one vehicle LATCH anchor unless speciﬁcally allowed by the vehicle manufacturer.

•Check that the LATCH Attachment Strap stays tight and does not slip from the tightened position. If it does, try another seating position or contact our Customer Service Department at (877) 456-5049 for assistance.

Figure 9

Figure 10

Doll or Stuffed Toy Booster Seat Instruction Manual

Page 7