SECTION
Removing
1.Push the front rigging release lever inward and rotate the footrest out.
2.Lift up on front rigging and remove from the wheelchair.
3.Repeat STEPS 1‐2 for opposite side of wheelchair.
Adjusting Footrest Height
Model PHWH93
NOTE: For this procedure, refer to FIGURE 6.2.
1. Remove any accessories from the footrest(s).
2. | Remove the footrest from the | Locknut | Footrest |
| wheelchair. Refer to Installing/ | Support | |
| Removing Front Riggings on page 17. |
| Coved Washer |
NOTE: Lay footrest on a flat surface to simplify |
| ||
| Hex Bolt | ||
section. |
| ||
3. | Remove the hex bolt, coved washers | Coved |
|
| and locknut that secure the lower |
| |
| footrest to the footrest support. | Washer | Lower |
4. | Reposition the lower footrest to the |
| |
| Footrest | ||
| desired height. |
|
|
5. | Reinstall hex bolt, coved washers and | FIGURE 6.2 Adjusting Footrest Height - | |
| locknut that secure lower footrest to | ||
footrest support. Tighten securely. | Model PHWH93 |
|
6.Repeat STEPS 1‐5 for the opposite side of the wheelchair footrest, if necessary.
7.Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Front Riggings on page 17.
8.Reinstall any accessories onto the footrest(s).
Model PH904A and PHAL4A
NOTE: For this procedure, refer to FIGURE 6.3.
NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way.
1.Loosen, but do not remove the lug bolt and locknut that secure the lower footrest to the footrest support.
2.Reposition the lower footrest to the desired height.
Footrest
Support 
Lug Bolt | Locknut |
|
Lower
Footrest
FIGURE 6.3 Adjusting Footrest Height -
Model PH904A and PHAL4A
Van Seat | 18 | Part No 1143195 |