Invacare PHWH93 manual Replacing Heel Loops, Raising/Lowering Elevating Front Riggings

SECTION 6—FRONT RIGGINGS

3.Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support.

4.Repeat STEPS 1‐3 for the opposite side of the wheelchair footrest, if necessary.

Replacing Heel Loops

NOTE: For this procedure, refer to FIGURE 6.4.

1.Note the position of hex bolt, coved washers and locknut for reinstallation.

2.Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support.

3.Remove the lower footrest.

4.Remove the phillips bolt, spacer and locknut that secure the existing heel loop to the lower footrest.

5.Slide the existing heel loop off the lower footrest.

6.Replace heel loop.

7.Reverse STEPS 1‐6 to reassemble.

Locknut	Coved
Coved	Washer
	Hex Bolt
Washer
Footrest	Phillips Bolt
Support	Spacer
Lower	Heel Loop
Footrest
	Locknut

FIGURE 6.4 Replacing Heel Loops

NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the spacer is secure.

Raising/Lowering Elevating Front Riggings

NOTE: For this procedure, refer to FIGURE 6.5.

1.Perform one of the following:

•Raising ‐ Pull back on the release lever and raise front rigging to the desired height.

•Lowering ‐ Support front rigging with one hand away from the release lever. Push release lever downward with other hand.

Release

Lever

FIGURE 6.5 Raising/Lowering Elevating Front Riggings

Part No 1143195 19 Van Seat