Invacare PHWH93 manual Adjusting the Height of the Center Mount Footrest

SECTION 6—FRONT RIGGINGS

Adjusting the Height of the Center Mount Footrest

WARNING

While the wheelchair is moving, minimum ground clearance for the front rigging is three inches. If the wheelchair is not moving, the front rigging MUST maintain a minimum of one inch ground clearance - otherwise personal injury and damage may result.

NOTE: For this procedure, refer to FIGURE 6.8.

1.Remove the two mounting screws that secure the footrest extension tube to the extension tube housing.

2.Adjust the footrest extension tube to the desired height and align the corresponding holes to the mounting holes on the extension tube housing.

3.Reinstall the two mounting screws to secure the footrest extension tube to the extension tube housing. Securely tighten.

4.Repeat STEPS 1‐3 for the other extension tube.

Extension Tube Mounting Holes

Mounting Screws

Height Adjustment

Holes

NOTE: Release Lever located towards the front or center of seat frame.

Seat Frame

Extension

Housing

Extension Tube

FIGURE 6.8 Adjusting the Height of the Center Mount Footrest

Part No 1143195 23 Van Seat