Bubblin’ Fun
6 |
|
Tab | Tab |
Reservoir Cover | |
• Replace the reservoir |
|
|
|
back into the bubble |
|
|
|
blower. Fit the reservoir | Reservoir | Reservoir | Bubble |
cover over the reservoir. | Cover | Blower | |
Align the tabs on the |
|
|
|
|
|
|
reservoir cover and snap them back into the bubble blower.
•To prevent leaking, be sure to allow the bubble blower to dry before bringing it indoors.
7
8
• Store bubble solution in the exhaust pipe.
No Bubbles?
•Check the bubble solution level.
•Check to see if bubble blower fan is operating.
-Remove the reservoir cover and reservoir (see page 19, step 4).
-Using a slotted screwdriver, rotate the lock fastener
1/4 turn 
to the unlocked position. Lift the seat and remove it from the vehicle.
-Locate the bubble blower connector and make sure it is connected securely.
-Lift the rear wheels of the vehicle off of the ground by placing an object under the rear of the vehicle. Press the power button on the steering wheel and place your hand over the opening of the bubble blower. If you feel air coming from the blower, the fan is working properly.
•Discard used bubble solution and fill with fresh bubble solution.
•Dried bubble solution may cause the bubble wheel in the reservoir to stick and not function properly. Remove the reservoir from the bubble blower and clean (see page 19, steps 4 and 5). Pour warm water into the reservoir and fill completely. Let it soak until the bubble wheel moves freely.
Disconnecting the Bubble Blower | • We do not recommend the use of silicones or oily | |||
• | The bubble blower can be disconnected and still allow | lubricants on this product. As with any bubble producing | ||
| your child to operate the vehicle. This is recommended for | toy, when even a very small amount of silicone or oily | ||
| indoor use. |
|
| lubricants are put into, or used near the fluid chamber, |
• | To unlock the lock fastener, use a slotted screwdriver | bubbles will not form. | ||
| ||||
| to rotate the lock fastener 1/4 turn |
| to the unlocked posi- |
|
|
|
| ||
| tion. Lift the seat and remove it from the vehicle. |
| ||
•Locate the bubble blower connector and unplug it from the motor harness connector.
•Replace the seat to the vehicle.
•To lock the lock fastener, use a slotted screwdriver to
rotate the lock fastener 1/4 turn 
to the locked position. 20