Britax Monarch manual Care and Maintenance, Removing Base Cover, Removing Backrest Cover

Care and Maintenance

Cover Removal

Tip: Use a blunt wooden rod (pencil, chopstick, etc.) to assist with untucking the cover hooks from the shell.

Before removing the cover, place booster seat on a level surface. Lift headrest to highest level, swivel backrest down and expand base to the widest position.

1 Removing Base Cover		A	Arm
	Locate the elastic loops at the back		Rest
	corners of the base. (Fig. A)
	Unfasten elastic loops from plastic		Base
	notches on each side of the base and
	slide the cover off.
2	Removing Backrest Cover	B
	Swivel backrest up. Locate the four
	notches on the rear of the backrest (two
	at the top and two at the bottom).
	(Fig. B)

	Unfasten the hooks (located under the
	backrest cover) by pulling the cover
	toward the center of the backrest and
	lifting the hooks up and out. Slide		C
	backrest cover off.	Backrest
3	Removing Headrest Cover
	Unhook elastic straps from clips at
	bottom of backrest. (Fig.C)	Base	Arm
	Locate the red tabs at each		Rest
	bottom corner of the headrest
	near the color-coded belt guides.
	(Fig. D) Push the cover back to		D Top of headrest
	release it from the tabs. Once the
	cover is off the tabs, slide it off the		Shoulder
	headrest.
			Belt Guide

4 To replace the cover, reverse the directions above.

Base

16