Britax 70 manual Rear-Facing Installation, Forward-Facing Installation

Page 54

Aircraft Installation

This child seat is certified for aircraft use. Most airlines in the U.S. and Canada will allow the use of a child seat as long as it is labeled as an approved child seat for use in aircraft and fits properly on the aircraft seat. Contact the airline about their policy prior to traveling.

The FAA recommends that a child weighing up to 40 lbs (18.1 kg) use a certified, harnessed child seat while traveling on an aircraft.

Install your child seat in a window seat to avoid blocking the aisle.

Rear-Facing Installation

For rear-facing aircraft installation (Fig. A), follow Rear-Facing Lap Belt Installation instructions on pages 36 – 39.

Forward-Facing Installation

For forward-facing aircraft installation (Fig. B), follow Forward-Facing Lap Belt Installation instructions on pages 48 – 51.

If the aircraft lap belt is too short, ask a flight attendant for a belt extender.

NOTE: Your child may experience discomfort if the buckle is located in the seating area of the child seat after installation.

A

b

52

Image 54
Contents MarathonTM Page Table of Contents Secure the top anchorage strap provided with this child seat Section Title Important Notes Certification RegistrationImportant Child Seat Usage Information Rear-Facing 5 40 lbs 2.3 18.1 kgForward-Facing Harness Height Compatible Vehicle Seat Belts Lap-Shoulder 3-Point Belt Has a latch plate that locks the vehicle belt Lap Belt Tightens by feeding the belt webbing back into the retractor Incompatible Vehicle Seat Belts Vehicle Seating Positions Child Seat Features Rear-Facing Belt Slot Base Harness Height Adjustment Loosen the harnessAdjusting Buckle Position Using the Chest Clip Fastening the Buckle Releasing the BuckleUsing the Lock-Offs To Open To CloseInfant Body Pillow Recline Positions Rear-FacingForward-Facing Acceptable overhangUnacceptable overhangUsing Lower Anchors and Tethers for Children Latch Top Using the Versa-Tether Rear-Facing Tether Connector Strap To remove the Versa-Tether from the carry clip Shows a tether acceptable for use Latch Installation Before You Begin Install with Latch as shown above Rear-Facing Installation Checklist Lap-Shoulder Belt Installation Before You Begin Install with lap-shoulder belt as shown above Loosen the harness Checklist Lap Belt Installation Before You Begin Install with lap belt as shown above Replace the cover and belly pad Checklist Check that your vehicle has lower anchors Install with Latch as shown above Forward-Facing Installation Check Versa-TetherTop Tether attachment Lap-Shoulder Belt Installation Before You Begin Install with lap-shoulder belt as shown above Open the locking tab Open the clamp Store excess webbing in the elastic strap Replace the cover Lap Belt Installation Before You Begin Install with lap belt as shown above Loosen the harness Checklist Rear-Facing Installation Forward-Facing InstallationSecuring Your Child Position the harness straps around the child Fasten the harness buckle Loosen the harness Care and Maintenance Care and Maintenance Cleaning the Cover Cleaning the HarnessCleaning the Shell Cover Replacement Care and Maintenance Cleaning the Buckle Remove the BuckleTo Clean Re-thread the Buckle Troubleshooting Problem The harness cannot be adjusted to its full heightLimited ONE-YEAR Warranty Page Britax Child Safety, Inc
Related manuals
Manual 70 pages 53.98 Kb