Britax 70 manual Compatible Vehicle Seat Belts Lap-Shoulder 3-Point Belt

Page 10

Vehicle Compatibility

Compatible Vehicle Seat Belts

NOTE: The information in this section only applies to installation with vehicle seat belts.

Vehicle seats and seat belts differ from vehicle to vehicle. Refer to your vehicle owner’s manual for specific information about your vehicle seat belts and their use with child seats.

Lap-Shoulder (3-Point) Belt

1.ALR (Automatic Locking Retractor) with Sliding Latch Plate

aHas a latch plate that freely slides along the vehicle seat

belt webbing.

bHas a retractor that stops the

belt from being pulled out again once the belt webbing has been pulled out at least 24 in. (61 cm).

cTightens by feeding the belt webbing back into the

retractor.

Latch

plate

8

Image 10
Contents MarathonTM Page Table of Contents Secure the top anchorage strap provided with this child seat Section Title Important Notes Certification RegistrationImportant Child Seat Usage Information Rear-Facing 5 40 lbs 2.3 18.1 kgForward-Facing Harness Height Compatible Vehicle Seat Belts Lap-Shoulder 3-Point Belt Has a latch plate that locks the vehicle belt Lap Belt Tightens by feeding the belt webbing back into the retractor Incompatible Vehicle Seat Belts Vehicle Seating Positions Child Seat Features Rear-Facing Belt Slot Base Harness Height Adjustment Loosen the harnessAdjusting Buckle Position Using the Chest Clip Fastening the Buckle Releasing the BuckleTo Open To Close Using the Lock-OffsInfant Body Pillow Recline Positions Rear-FacingForward-Facing Acceptable overhangUnacceptable overhangUsing Lower Anchors and Tethers for Children Latch Top Using the Versa-Tether Rear-Facing Tether Connector Strap To remove the Versa-Tether from the carry clip Shows a tether acceptable for use Latch Installation Before You Begin Install with Latch as shown above Rear-Facing Installation Checklist Lap-Shoulder Belt Installation Before You Begin Install with lap-shoulder belt as shown above Loosen the harness Checklist Lap Belt Installation Before You Begin Install with lap belt as shown above Replace the cover and belly pad Checklist Check that your vehicle has lower anchors Install with Latch as shown above Forward-Facing Installation Check Versa-TetherTop Tether attachment Lap-Shoulder Belt Installation Before You Begin Install with lap-shoulder belt as shown above Open the locking tab Open the clamp Store excess webbing in the elastic strap Replace the cover Lap Belt Installation Before You Begin Install with lap belt as shown above Loosen the harness Checklist Rear-Facing Installation Forward-Facing InstallationSecuring Your Child Position the harness straps around the child Fasten the harness buckle Loosen the harness Care and Maintenance Care and Maintenance Cleaning the Harness Cleaning the CoverCleaning the Shell Cover Replacement Care and Maintenance Cleaning the Buckle Remove the BuckleTo Clean Re-thread the Buckle Troubleshooting Problem The harness cannot be adjusted to its full heightLimited ONE-YEAR Warranty Page Britax Child Safety, Inc
Related manuals
Manual 70 pages 53.98 Kb