Graco UA105 operating instructions Assembly Instructions

Page 6

Assembly

Instructions

F ront wheel

1.Release locking latch. Unfold the stroller. Make sure both sides of the frame lock into place. Remove foam packing tubes from rear axle/ brake.

3.Remove foam pack- ing tubes from rear leg tubes on the frame. At- tach rear axle assembly onto rear leg tubes by inserting the left side a little bit and the insert- ing the right hand side. Press both of them together until the spring loaded buttons click into place.

2.Lean the stroller backwards with the

front forks pointing up. Inflate tires before assembly. Assemble the front wheel as shown. Tighten the lever on the axle until it is very close to contacting the fork then close the lever.

4.Remove plastic packing tubes from the rear wheel axle. Slide wheel onto axle and push until you hear a click. Make sure it is properly secure. Push down on spring Clip if necessary.

6

ASSEMBLY INSTRUCTION

 

 

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Urban Advantage Stroller Warranty Express Limited Warranty Table of Contents Before Assembling Please Read Thoroughly Prior to Assembling Urban AdvantageAssembly Instructions Assembly Instructions Assembly Instructions To Open Stroller How to Properly Use the Urban Advantage StrollerTo Recline Seat AND/OR Adjust Foot Retainer To Secure Child in StrollerTo Raise Footrest To Recline SeatTo Raise Seat To Lower FootrestTo Adjust the Kickstand Options for Using the Child TrayOptions for Using the Swivel Wheel Lock AIR Pump WheelsTires Wrist StrapTo Fold the Urban Advantage Using the Urban Advantage as a Travel System Safety Safety FAQs Do you have a car seat that fits in the stroller?Can you attach a ride along to the stroller? Troubleshooting My stroller seems to pull and lean to one sideTroubleshooting Care Maintenance Thank you
Top Page Image Contents