7.NEVER put two LATCH connectors on one vehicle LATCH anchor .
8.Test infant restraint for secure installation as described in infant restraint “Final Safety
Check” page 42.
9.Check that the LATCH stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Graco at
10.To remove LATCH, push button while pulling on the LATCH belt as shown .
11.Press and hold LATCH release hinge .
12.Push connector in, lift connector up and
pull out (away from anchor point) .
13. Repeat steps 11 and 12 for other connector.
31