Graco PD156938C owner manual REAR-FACING Installation with Latch

Page 16

REAR-FACING INSTALLATION WITH LATCH

1Adjust child restraint to recline position (fig. a). Flip recline feet under child restraint for rear facing use.

Make sure Forward Facing LATCH belt is stored. (see fig. c, pg. 37)

2Place rear-facingon vehicle seat equipped with LATCH anchors.

3For ease of installation, extend LATCH belt to its maximum length.

4Hook connectors to vehicle lower anchors (fig. b). Belt must lay flat and not be twisted. Pull connectors to be sure they are securely attached to the anchor points. (fig. c).

5Press down firmly in center of child restraint while pulling LATCH adjustment belt. (fig. d).

6Pull front to back and left to right at belt path to check for secure installation (fig. e).

Check that the lower anchor belt stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service.

7Check level indicator on child restraint (fig. f).

Vehicle must be on level ground and child in child restraint when checking level indicator.

Ball MUST be entirely in green zone (fig. f). If necessary, place rolled towels under child restraint, at vehicle seat crease, until entire ball is in green zone. Then re-check level indicator.

DO NOT use tether rear-facing. Tether must be stored (see “Tether Storage” page 47).

Periodically check that child restraint is securely installed and properly leveled; adjust if necessary.

To remove LATCH, (see “Removing LATCH from Vehicle Anchor Points”, p. 36).



Image 16
Contents Child Restraint Read this ManualTable of Contents Child restraint labels Important Information For recall informationPage Page Page Page Basic Information What is LATCH? Fig. c Latch System Height & Weight Limits Preterm or Low Birthweight InfantsHeight & Weight Limits Outgrowing Child RestraintFeatures LatchREAR-FACING Installation with Latch REAR-FACING Installation with Latch FORWARD-FACING Installation with Latch FORWARD-FACING Installation with Latch REAR-FACING Installation with Vehicle Seat Belts REAR-FACING Installation with Vehicle Seat Belts FORWARD-FACING Installation with Vehicle Seat Belts FORWARD-FACING Installation Placing Child in Child Restraint Check harness systemPlacing Child in Child Restraint Placing Child in Child Restraint Harness Tie Operations & Adjustments fig. aHarness Strap Harness Tie Bucklefig. d fig.g fig. e fig. h fig. f Changing Harness Strap slots fig. d fig.e fig. f Slot For Infants or Small Toddlers When using harness slot Removing Latch from Vehicle Anchor Points fig. b fig. cRear Facing Storage Vehicle Seat Belts Belts Forward of Seat Crease Lap Belts Manually Adjustable Vehicle Seat BeltsVehicle Seat Belts Passive Restraint Lap Belt with Motorized Shoulder Belt Passive Restraint Lap or Shoulder Belt Mounted on Doorfig. a Pull Vehicle Seat Belts Locking Clip fig. a Additional Information Additional Information Body Support certain modelsHead Support certain models Additional Information fig. a Additional Information Aircraft Use Harness Straps & Latch BeltSecond Hand Child Restraint Page Page Replacement Parts Read this ManualAsiento de seguridad infantil Manual del propietario LEA Este ManualAntes de Empezar Tabla DE ContenidoUtilización Información especial Lista de control de seguridadInformación de registro Para obtener información sobre Información ImportanteLas retiradas Advertencia Prevenga lesiones graves o la muerte Advertencia Prevenga lesiones graves o la muerte Advertencia Prevenga lesiones graves o la muerte Advertencia Prevenga lesiones graves o la muerte Información Básica ¿QUÉ ES EL LATCH? Sistema Latch para vehículos¿QUÉ ES EL LATCH? Sistema Latch Límites DE Altura Y Peso Orientado hacia atrásAdvertencia Características Instalación Orientada Hacia Atrás CON Latch Instalación Orientada Hacia Atrás CON Latch Instalación Orientada Hacia Delante CON Latch Cont Colóquelo orientado hacia atrás en el asiento del vehículo Instalación DE Orientacion Trasera CON LOS Colóquelo orientado hacia delante en el asiento del vehículo Instalación Orientada Hacia Delante CON Colocar AL Niño EN EL Asiento DE Seguridad Compruebe el sistema del arnésColocar AL Niño EN EL Asiento DE Seguridad Colocar AL Niño EN EL Asiento DE Seguridad Cierre del Arnés Hebilla Operaciones Y Ajustes Correas del arnésOperaciones Y Ajustes Hebilla Cierre del arnésPosiciones reclinada / vertical fig. d fig.g fig. e fig. h fig. f Cambiar las ranuras de las correas del arnés fig. a fig. b Sujete las correas del arnésa la placa de unión Para bebés o niños pequeños Cuando usa las ranuras del arnés Retirar el Latch de los puntos de anclaje del vehículo Almacenaje Latch Cinturones DE Seguridad DEL Vehículo Cinturones DE Seguridad DEL Vehículo Cinturones ubicados delante del pliegue del asientoCinturones de regazo ajustables manualmente Cinturones de regazo con retractor No SE Debe usar con ningún asiento fig. a Jale Cinturones DE Seguridad DEL Vehículo Clip de cierre Dentro de 1 pulgada 2 cm Información Adicional Almacenaje del anclajeInformación Adicional Soporte de la cabeza ciertos modelos Soporte de la Advertencia Soporte de la cabeza Cuidado y limpieza Retirar la almohadillaUso en aeronaves Correas del arnés y del sistema LatchNotas Notas Repuestos Como se indica