Graco 7965, 7950, 7970, 7955 manual To Unfold Stroller, To Raise Footrests, To Use Brakes

Step 2.

Place ONE rear wheel, red retainer, cap, and hubcap (only on certain models) on one end of rear axle in order as shown below. Push red retainer onto axle BEFORE attaching white

cap. Do not place other wheel on axle at this time.

	Wheel	Hubcap (only on
	Cap (white)	certain models)
Spokes	Attach AFTER
	retainer is
toward
	on axle
inside

Rear	Retainer (red)
axle	Wide end toward wheel

Snap red retainer into axle groove. Then snap cap over the

red retainer as shown. Be sure cap is snapped securely over red retainer. Snap the hubcap

(only on some models) on last.

Step 6.

Only on certain models, snap the remaining hubcap onto rear wheel to complete the assembly.

To Unfold Stroller

Step 1.

Release the latch found on one side of stroller.

Step 2.

Unfold stroller as shown.

Be certain the stroller is fully erected and latched before allowing your child near the stroller.

Step 3.

Unsnap the basket flap from the rear brace, and slide rear axle with wheel assembly through the hole in one axle bracket.

Continue to push the rear axle into the hole of the other axle bracket.

Step 4.

Snap the basket flap around both the rear axle and the rear brace.

This may be easier if the stroller is partially folded. See the “To Fold Stroller” instructions.

Step 5.

Place other rear wheel onto the rear axle. Snap the red retainer and cap onto the axle as shown in Step 2.

To Raise Footrests

Lift footrest and hook wire into footrest bracket.

To Use Brakes

Always apply both brakes to park stroller.

Push DOWN to park.

Lift UP to stroll.

7 8