Graco 1751470, 1763611, 1762542 ➋ ➌, Installing the Infant Restraint/Base Using Vehicle Belt

6.3Installing the Infant Restraint/Base Using Vehicle Belt

You must carefully follow the instructions provided by your vehicle manufacturer, in addition to the information in this manual. Before proceeding, be sure you have read and understood section 5, “Infant Restraint Location” on p. 20-25.

Make sure vehicle is on level ground so that	➊
the level indicator, which is attached to the
infant restraint, can be used to properly
recline the infant restraint ➊.

If a front passenger seat is used, slide the vehicle seat rearward as far as possible from the dashboard. If a rear seat is used, make sure the seat in front of it is moved forward enough and is upright enough to allow room for the infant restraint.

1.Remove infant restraint from base,

regardless of whether or not you plan on using the base.

2.Place the base ➋ or infant restraint without base ➌ in a rear-facing position in a forward-facing vehicle seat.

➋ ➌

30