Step 4.
Pull firmly on each axle mount to be sure it is securely attached.
If the axle mounts do not snap on the legs, they may be facing the wrong way. Remove the axle mounts with brake wire and face them the other way.
Step 5.
Insert rear axle (longer axle) |
|
through holes in the rear axle |
|
mounts. It may be necessary to |
|
twist the axle mount slightly to | Axle |
get the axle through the holes. |
|
To Assemble Rear Wheels
Place parts in order on rear axle as shown. If the hub adapter will not go against the rear axle mount, push the brake wire down and check to make sure the hub adapter is aligned in the wheel correctly.
| Hub adapter |
| toward inside |
| Wheel |
Rear | Cap (white) |
Attach AFTER | |
axle | retainer is on axle |
| Retainer (red) |
| Wide end toward wheel |
Be sure cap is snapped securely over red retainer.
To Assemble Front Axle*
Pointed
Step 1.side to back
Put both front axle mounts on
the frame. (The pointed side of
the axle mount faces the rear of Footrest the stroller.)
Step 2.
Put the axle through the hole in the axle mount and frame. It may be necessary to twist the axle mount slightly to get the axle into the hole.
To Assemble Front Wheels*
Place parts in order on front axle as shown. Push red retainer onto axle BEFORE attaching white cap. Repeat on other side.
Wheel
Axle | Cap (white) | |
Attach AFTER | ||
| ||
| retainer is on axle | |
| Retainer (red) | |
| Wide end toward wheel |
Be sure cap is snapped securely over red retainer.
To Assemble Front Swivel Wheels*
To prevent
serious injury or death | End cap | |
from choking, remove and | ||
| ||
IMMEDIATELY discard plastic |
| |
end caps on the front leg pins. |
|
Step 1.
Line up pin with a wheel |
|
assembly as shown. Plastic | Plastic |
snap inside wheel mount | |
must be away from pin. | snap |
Step 2.
Push wheel assembly onto pin until it snaps into place.
Step 3.
Repeat for other wheel assembly.
Pull firmly on each wheel assembly to be sure the wheel assemblies are securely attached.
*On certain models
7 |
|
8 | |
|
|