CHANGING TABLE INSTRUCTIONS (ON CERTAIN MODELS)
Parts List
Step 1.
Lay changing table flat on floor with short side in front of you and belt facing up. Gently slide one long tube into opening on long side exactly as shown.
CHECK that you have all parts listed below BEFORE assembling your changing table.
No tools required.
Long tube (2)
Short tube (2)
Changing pad
Changing
table
Accessory bag
Repeat on other side.
Step 2.
Slide one short tube into opening on end as shown.
For proper orientation, be sure folding side of hinge faces pad as shown.
DO NOT insert other short tube at this time.
Long
side
Short side
Fold side
of hinge
To Use Your Changing Table
To protect your child from falls and other injuries:
•Always stay within arm’s reach of your child when
•using the changing table. Always use waist belt
•when child is on the changing table. Never leave
•child unattended.
•The changing table is designed for use only with
•this Graco Pack ’N Play. Do not attempt to use it
•with any other product. Before each use, make
•sure the changing table is properly secured to
•the Pack ’N Play by pushing down firmly in the
•middle of the changing table. The changing table
•should not fall.
•Do not use the changing table as a sleeping or
•play area.
•Weight limit for the changing table is 25 pounds
•(11.3 kg). Do not use the changing table as extra
•storage. Always remove the changing table when
•your child is in the Pack ’N Play.
•The Pack ’N Play changing table can be used on
•the floor without being attached to the Pack ’N
•Play. Never place the changing table on a piece of
•furniture, bed, counter or any raised surface from
•which the changing table or your child could fall.
Step 3.
Turn up long tube so that its end points down.
Insert end of long tube into opening on end of short tube as shown.
DO NOT slide short tube up around the bend of long tube until you have finished next step.
Make sure fabric does not get caught in opening when inserting long tube into short tube.
Step 4.
Repeat step 3 on other end of short tube, then slide short tube ends up onto long tubes.
TO AVOID TEARING FABRIC, slide this end up before proceeding with step 5.
14
Short tube side
Slide ends up