At first your Pack ’N Play may be like a new pair of shoes. You may need to break it in by slightly stretching the netting and fabric. If the center does not stay down, place some weight (several books) in the center of the unit and let it stand overnight.
To Use as a
Playard/Portable Crib
Place mattress into your unit with padded side up.
Always use your unit with mattress installed soft side up.
Slide the two VELCRO® straps through slots in bottom of Pack ’N Play and fasten to VELCRO® on underside. This will prevent mattress from moving.
Your Pack ’N Play is ready to use.
To Fold Your Pack ’N Play®
Step 1.
Lower the back flap. Apply locks on wheels or casters, if present. Release the two VELCRO® straps under the Pack ’N Play, and remove the mattress.
Step 2.
IMPORTANT:
Raise center halfway BEFORE unlocking rails.
Grasp the red handle on the center of the floor as shown.
Push down and turn handle. Then pull up approximately halfway to the top rails.
Step 3.
The top rail has a center piece with two tubes hidden under the fabric. The button on the bottom of the center piece releases the two tubes when it is pushed up.
Center
piece
Tube
Push UP button 
under fabric
To fold the top rail:
!Lift up slightly on the top rail.
! Push up on the button located under ! the symbol to release the two tubes.
!Push down.
HINTS:
!If top rails do not unlatch, lift
!the center of the floor higher.
! Both tubes must be released
!for the top rail to fold.
Step 4.
Pull center up all the way.
5 | 6 |