SEAT PAD ASSEMBLY (continued)
❃Harness Assembly
1Thread each end of harness strap from back to front through slot in tongues(fig. l).
DO NOT twist harness strap.
2Thread each end of harness strap through chest clip.
Chest clip MUST be
3Thread each end of harness strap through matching slots of seat pad and car
seat (fig. n).
Read instruction manual for proper harness strap adjustments.
4Adjust harness strap length by inserting metal rod into loops that will position harness strap for proper snugness (fig. o).
Make sure the ROD is threaded through the same loop position on both sides.
5Replace metal rod into side slots and slide metal rod down below tab (fig. p).
Make sure tab holds metal rod securely.
WARNING
Only use metal rod supplied by Graco or child will not be restrained.
10