ENG CDN To install, Two-way swing | The First Years Swing Gate

ENG CDN To install

!WARNING:

ALWAYS use the hardware mounting method when installing the All-Clear Swing Gate at the top of stairs, as it provides maximum security. Do not use in pressure mount mode at the top of stairs. Adult assembly required.

The First Years All-Clear Swing Gate can be either pressure mounted or hardware mounted. Once hardware mounted, you can also switch back and forth for use in pressure mount application.

ENG CDN

Hardware mounting for swing-thru convenience

Hinge side

Two-way swing

minimum opening of 30" wide

Pressure mounted side

Mounting area

For proper installation, the gate must be installed in an opening where wall on both sides is straight and the floor is level.

NOTE: Hinge bracket spacers may be necessary if there’s a baseboard. (See page 5 for installation instructions.)

Mounting surfaces

Remember that the hinge and wall mount brackets must be firmly screwed into solid wood surfaces or solid wood studs. Do not attach to metal railing or metal wall covering, or to sheet rock, plaster or lathe board (unless you have verified that a stud is directly underneath).

Determine gate swing

Two-way swing (diagram 1)

• Minimum opening of 30" wide

Hinge side

One-way swing (for use at top of stairs)

27.5" — 42.5" wide

Stairs

Safety bracket side

One-way swing (diagram 2)

• Stairway with an opening 27.5–42.5" wide (must use safety bracket)

One-way swing (diagram 3)

• Stairway with an opening 30–42.5" wide (must use safety bracket)

You will need:

•Drill with 1/8 inch drill bit

•Masking tape

•Phillips screwdriver

Safety bracket side

One-way swing (for use at top of stairs)

30" — 42.5" wide

Stairs

!WARNING:

When mounting at the top of stairs ALWAYS assure gate swings away from stairs and ALWAYS use safety bracket.

Hinge side