The First Years Swing Gate manual Pressure mounting/Adjusting width, Panels out to adjust

ENG CDN

13

Pressure mounting/Adjusting width

NOTE FOR HARDWARE INSTALLED GATE: Follow steps 1-5 to adjust

14 the width of your gate to finish installation.

Place the gate in a doorway or hallway that is at least 27.5 inches wide but no wider than 42.5 inches.

IMPORTANT: Hold the gate upright during installation, flush against floor.

or	NOTE: Do not use pressure mount mode at top of stairs. Hardware
	is included for top of stair use.

1. Holding the release handle with one hand, first use your thumb to push and slide the release button that is most comfortable for you, as shown in diagram bn, then lift up on the release handle, as shown in diagram bo.

NOTE: We designed the All-Clear Swing Gate with two release buttons to make it easy to open regardless of where you are standing when you want to open the release handle. You only need to push and slide ONE release button in order to lift the release handle.

15

a

b

16c

2.Open the top and bottom adjustment buckles as shown in diagram bp.

a.Push the adjustment buckle tab to the left and hold in place.

b.Now lift up the adjustment buckle to release. Be sure to release both the top and bottom buckles.

TIP: You may find it difficult to open the adjustment buckles. The tightness you may encounter is an intentional safety measure that we’ve built-in for optimal child security. To make it easier to open the adjustment buckles, try placing the gate flat on the floor with buckle side facing up towards you. Then, follow steps a. and b. above and continue with the installation.

NOTE: Illustration bq shows the gate pressure mounted.

3.With the release handle up in the unlocked position, slide panels (A) until the adjustment knobs hit the door jam, as shown in diagram bq.

TIP: Lean over the top of the gate. Grasp each panel in center at point A and simultaneously push each panel to slide in opposing directions.

b		IMPORTANT: Always hold the gate in the center when sliding
		the panels out to adjust.
		NOTE: If the gate is being	17
		pressure mounted in an
		opening with baseboards
		or other uneven surface,
	a	you may need to adjust
		the adjustment knobs for
		an optimal fit, as shown in
		diagram br.

b

4.While holding gate on point A, press the adjustment buckles (B) down to lock panels in place at the desired width as shown in diagram bq.

5.Lower release handle (C) down to lock as shown in diagram bq. Pads will press up against mounting surface. Your gate is now locked!

7