"Fast Heat Up" function
After a cooking function has been selected and the temperature has been adjusted, the cavity will gradually heat up until the selected temperature is reached. This will take from 10 to 15 minutes, depending on selected function and temperature.
If it is necessary to reach the required temperature in a shorter time, the "Fast Heat Up" Function can be used.
1)Switch the oven on by pressing button 
.
2)Set the required cooking function and temperature as explained in the previous pages.
3) Set the temperature by pressing button “ “ or “
“. The temperature will appear on the display.
4)Press button B . The temperature display will show "FHU" (Fig. 18).
5)press button 
and the symbol “°” will flash for approximately 10 seconds. Now it is possible to select the required temperature by pressing button “ “ or “
“.
4)When the required temperature is reached, an acoustic alarm will sound for a short time, and the temperature display will revert to the set temperature.
This function can be used with any cooking function or temperature.
Demo mode
This mode is intended to be used at the shops to dem- onstrate the oven functionality without any power con- sumption except the oven lamp. To activate this func- tion the appliance should be in
—Press button B and “ 
“ for approximately 2 sec- onds (Fig. 19). An acoustic alarm will sound for a short time.
—Press button 
and the “id” indication will appear on the display.
All oven functions can be selected.
The thermometer symbol 
will not flash anymore and “id” indication will be replaced by number dig- its.
Follow the above described procedure to disable the demo mode.
Error code
The electronic programmer does a continuous diagnostic check of the system. If some parameters are not cor- rect, the control unit will stop the activated functions and it will show on the display the corresponding error code (Fig. 20).
For further details, refer to chapter "Something not work- ing“ on page 20.
B
Fig. 18
B
Fig. 19
B
Fig. 20
11
