Assembly
IMPORTANT! Before each use or assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact
Leg
1 | 1 | 1 |
|
4 4 4 4 4 4
Tape
1 1 1 1 1 1
3 3 3 3 3 3
2 2 2 2 2 2
Base Socket
1
• Locate the leg with 
tape on it.
•Locate the matching tape covering the socket in the base.
•Align the tab on the leg with the slot in the base socket.
•Insert and “snap” the leg into the base socket.
Upper Rail with Leg
2Tape
PUSH
Upper Rail
with Leg
PUSH
4 4 4 4 4 4
2 | 2 | 2 | 1 | 1 | 1 |
3 3 3 3 3 3
3 | 2 | 2 | 2 | 2 | 2 | 2 | 2 | Tape |
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
Base Socket
•Position the upper rail with leg so that the leg with 2 tape is over the base socket with matching tape.
•Insert and “snap” the leg with 2 tape into the socket with matching tape.
•Now, firmly push the upper rail above the leg with 
tape on it. Make sure you hear a “snap”.
•Firmly push the upper rail above the leg with 2 tape on it. Make sure you hear a “snap”.
•Pull up on the upper rail to be sure it is secure.
2 2 2
Wire Connector
2 | Cardboard |
|
4 Tape 
3 Tape 3 3 
3
4 4 
4
Base Socket
•Locate the upper rail with leg and 2 tape on it.
•Remove the cardboard attached to the wire connector. Throw the cardboard away.
•Pull the wire connector out from the hole in the bottom of the leg.
4 4 4 4 4 4
1 1 1
3 3 3 3 3 3
2 | 2 | 2 |
4 Base Socket
• Locate the legs with 3 4 tape on them.
•Locate the matching tape covering the sockets in the base.
•Align the tabs on the legs with the slots in the base sockets. 4 • Insert and “snap” the legs into the base sockets.