Assembly
PUSH
| Bell | Upper |
|
|
|
| |
Upper Rail |
| Rail | PUSH |
| Slot |
PUSH
4 4 4
3 | 3 | 1 | 1 | 1 |
3 |
|
|
2 2 2
5
•Fit the upper rail onto the legs, as shown.
•Push down firmly above each leg until, you hear the upper rail “snap” into place on each end.
•Pull up on the upper rail to be sure it is secure.
Note: Remove the tape on the legs and around the base sockets. Throw the tape away.
Trumpet
Upper | “T” End |
Rail Slot |
|
7
•At an angle, fit the single tab on the bell into the slot in the upper rail.
•Now, push and “snap” the other two tabs on the bell into the slots in the upper rail.
Mirror
Slots
6 | 8 |
|
•Fit the “T” end of the strap on the trumpet through the slot in the upper rail. Pull the trumpet to be sure it is secure in the upper rail.
Hint: You may want to use the end of a slotted screwdriver to push the “T” end of the strap through the slot.
•Position the mirror so that it is toward the inside of the product.
•Insert and “snap” the tabs on each end of the mirror into the matching slots in the upper rail.
5