Lanier LASER 200 warranty Firewall,behind theblind nuts

LANIER – 1/3rd Scale Laser 200 ARF -INSTRUCTIONS

firewall,behind theblind nuts.

69.Drill(5)3/32”holeson each sideofthefirewall, through thefusesidesabout1”deep. Pressa wood toothpick into thehole,then cutoffflush with som ewiresnips. Apply severaldropsof thin CA on each toothpick.

70.M ark on thefirewallthelocation wherethe throttlecontrolrod should passthrough. Drill them arked holewith a1/8”aircraftdrillbit.

72.M akesureyourcarburetorandthrottleservoare atlow position.Reverseyourservoifnecessary. Thread the2-56 clevison the12” rod,thensnap theclevison theservo arm . Installan EZ connectorin theholeon yourcarburetor approxim ately thesam elength oftheservo arm . Trim thethrottlecontrolrod to approxim ate length,then insertthrough theholein theEZ connector. Tightentheconnectorenoughtotest thethrow oftheservo and adjustasneeded to allow form axim um throw,butnotbind the servo.W hensatisfied,trim thecontrolrodto¼” pasttheEZ connector. Installtheservo horn screw . W hen everything isfit,then fuelproof thefirewallwith polyurethaneorthinned epoxy.

73. Testfitthecowlovertheengineto seewhat

needsto berelieved. SH AVE TH E

TO P CO RNERS O F TH E FIREW ALL TO ELIM INATE RUBBING O N CO W L.

71.Using yourservo asaguide,gluethetwo hardwoodservoblockstothefusesideusing30 m inuteepoxy.Cutasm allpieceofbalsa trianglestock to fillettheservo railsand fasten with CA.

74.Usem asking tapeto m ark theareasthatneed to berem oved forthehead oftheengineto clear thecowl,then testfit.

© 2002 LanierR/C Page-11