and Sensor Level parameters. Please note, the PIR is strongly sensitive to ambient temperature. The greater the temperature difference between the environment and your subject, the farther the possible sensing distance. The average sensing distance is about 45 ft.
Before leaving the camera unattended, please check for the following:
•Are the batteries or DC power supply inserted/connected with correct polarity and is the power level is sufficient?
•Does the SD card have sufficient available space and is its write- protection (lock) switch off?
•Is the Power switch in the ON position? (do not leave it in SETUP).
PLAYING BACK/DELETING the PHOTOS/VIDEOS
After you have setup, mounted and activated your Trophy Cam, you will of course be eager to return later and review the images it has captured for you. There are several different ways this can be done.
Reviewing Images on an External Video Monitor
A TV monitor can also be used to play back pictures (or videos) from the device. Connect a TV monitor or a viewing device (such as a digital picture frame) that has a standard composite video input (RCA jack) to the Trophy Cam ‘s “TV Out” mini jack using the supplied cable (see next page). Then:
•Put the power switch in SETUP mode (switch to OFF first).
•Press the OK key. The most recently captured image will be shown on the video monitor. For video clips, press the SHOT (RIGHT) key to start playing, press again to stop.
•Press the UP key for the previous photo or video and the DOWN key for the next one. When viewing images, the total number of all images in the SD card and the index of the displaying image are shown in the center of LCD and at the bottom of the video monitor respectively.
•Press the OK key to return to live preview state (SETUP mode) when playback is finished.
24