Sony TS-DSC-P41-01 manual Day, Night, or 24 hour operation setting

Page 8

TrackSnap Manual

Model TS-DSC-P41-01

Inside Your TrackSnap Camera

PixController Main Board Features

Board can be mounted vertically or horizontally. The unique dual element PIR sensor enables the camera to be used in any orientation.

External light port. This can switch up to a 4.2 amp supply for lights and IR LED arrays.

Dual LED’s for better board diagnostics. The unique LED’s design, super bright red control LED, and green PIR LED is used on all of our motion sensing boards. The LED layout is designed to shine through the PIR lens in your case.

Controls LANC Video Camcorder, Digital Cameras, and 35mm Cameras all on one board!

Fast re-trigger PIR! Can be re-triggered within 1 second With this you get features like continuous filming as long as motion is present for LANC camcorder setups.

Fast and Slow camera start-up modes. Allows you to use any kind of memory card in your camera.

Day, Night, or 24 hour operation setting.

Auto walk test mode on power up. The walk test mode will blink every time you walk into the PIR detection area. It gives instant feedback.

Low battery level detection - the green PIR LED will blink when a low battery is detected.

10-Postion DIP switch so you can easily configure board settings.

Tiny board size. Fit a Sony DSC-P41 into a Pelican 1060 case with room to spare. PIR sensitivity POT to adjust the PIR detection range.

Day/Night sensor POT to adjust the light detection level. There is a DIP switch setting in which you can calibrate this setting. The red control LED will be on when it detects darkness and gives you continuous feedback.

Auto PIR shut-down on low battery detection. Minimises false photos when battery becomes low!

Reverse polarity circuit. This will protect your board if you install a battery backwards. There is an on- board fuse to protect your investment!

Professionally built, assembled, and tested.

TTL Slave Flash trigger output. – To be used in conjunction with an external Slave Flash board. This allows the use of very inexpensive Digital CMOS board cameras.

Version

Page 8 of 12

Released

TS P41.2

This document comprises information provided by Suppliers and is

 

 

assumed to be correct.

 

Image 8
Contents TrackSnap Manual Sony DSC-P41 Released TrackSnap Setup TipsIntroduction PIR Motion Sensors Basic Overview for Effective Use PIR Sensor Detection AreaAdjusting the Day/Night Cal. POT Auto Walk-Test mode on power upAdjusting the PIR Sensitivity POT Mode PIR DelaySwitch Picture Mode Camera ModeCamera Original LE Camera LERecording Time Day, Night, or 24 hour operation setting Professionally built, assembled, and testedTrackSnap Manual Mounting the PIR Lens Fast Re-Trigger PIR detection electronicsLE Board Mounting PIR Sensor Considerations Pelican 1060 Micro CaseTroubleshooting Sony DSC-P41 Camera Settings and SpecificationsDefault TrackSnap Camera Setup for fastest shutter times Symptom Cause Solution