Sony TS-DSC-P41-01 manual PIR Delay, Switch, Mode

TrackSnap Manual Model TS-DSC-P41-01

DIP Switch Settings

PixController 10-Position DIP Switch

Introduction

The 10-Position DIP switch on the PixController board is used to setup how the board controls the attached cameras, functions in day only, night only, 24 hour mode, and many more features. Listed below are instructions on how to setup the DIP switch feature on the LE board.

Default Setting

The default settings for your camera are marked in Yellow

All switches Down (Off) except SW6 and SW10 Up (ON) and a summary is listed:

•10 Sec PIR Delay

•24 hour mode of operation

•Sony P32/P41 Camera

•Continuous movement movie setting

•Green PIR LED ON

PIR Delay Setting

Switches 1 and 2 control the delay between PIR events. This setting is used so you can limit or not limit the number of photos taken when a motion event triggers your board. For example when you set your system up on a track you will want the 10 second delay setting so you can capture as many photos as possible, but when setup over a feeder you want to use the 10 minute PIR delay so you limit the number of photos of one animal.

PIR Delay

10 Seconds

2Minutes

5 Minutes

10 Minutes

Switch 1

Down/Off

Down/Off

Up/On

Up/On

Switch 2

Down/Off

Up/On

Down/Off

Up/On

Mode Setting

Switches 2 and 3 control the mode of operation of your PixController board. Here you can setup if the board is to function 24 hours a day, night only, or day only. The last setting sets up the day/night sensor light detection level. This is useful for setting up your PixController board to detect light/darkness levels.

Mode

24 Hour Operation

Night Only

Day Only

Day/Night Sensor Calibration.

Switch 3

Down/Off

Down/Off

Up/On

Up/On

Switch 4

Down/Off

Up/On

Down/Off

Up/On

Version	Page 5 of 12	Released
TS P41.2	This document comprises information provided by Suppliers and is
	assumed to be correct.