6 | FlexCam iCam Digital — Getting Started |
Getting Started
Connections
You can connect the FlexCam iCam Digital to a TV, a VCR or an LCD projector using the included 12'
To connect to a TV, VCR or projector
1.Connect the
Note: If needed, use the
2.Attach the power plug to the power jack on the back of the camera and plug the power adapter into the wall.
To | To |
Input | Input |
| To Composite |
| Composite Adapter |
POWER
DC 12V
FlexCam iCam Digital
Figure 4. Connection to an S-video display device
To connect the camera to a computer
1.Connect the USB cable of the FlexCam iCam Digital to the USB input on the back of the computer.
2.Attach the power plug to the power jack on the back of the camera and plug the power adpater into the wall.
To USB | To USB |
Connector | Output |
PC or Mac
To Outlet
To Power
POWER
DC 12V
FlexCam iCam Digital
Figure 5. Connection to computer
FlexCam iCam Digital — Getting Started |
| 7 |
|
Sofware drivers for Windows
Before you can use your FlexCam iCam Digital with a computer, you must install the proper USB drivers on your PC. The drivers are found on the USB Software and Driver Disk that came with your camera. Depending on the Windows version you are using, the installation process may vary slightly. The new hardware screens on your computer may not look exactly like the ones pictured in this section. If the Found New Hardware Wizard does not automatically locate the drivers, you may need to manually direct your browser to the NUVSION.sys file on the ArcSoft CD. After the drivers are properly installed you will need to install the ArcSoft Software Suite that includes VideoImpressions and PhotoStudio. For information on installing the ArcSoft Software Suite, please refer to page 11.
To install the drivers on Windows
1.Insert the USB Software and Driver Disk into the
2.Plug in the FlexCam iCam Digital.The Found New Hardware Wizard will open.
3.Click Next.
Figure 6. Found new hardware
Technical Services Group ~ | Technical Services Group ~ |