Sofware drivers for Macintosh

10	FlexCam iCam Digital — Getting Started

Before you can connect your FlexCam iCam Digital to a Macintosh, you must install the USB drivers. The drivers are found on the USB Software and Driver Disk that came with your camera. The FlexCam iCam Digital is compatible with Mac OS 8.6 – 9.2.

To install USB drivers on a Mac

1.Insert the USB Software and Driver Disk into the CD-ROM drive.

2.Double-click the USB Software and Driver Disk icon to open the CD content window.

3.Double-click the FlexCam iCam Digital folder icon.

Figure 11. ArcSoft on Mac

4.Double-click the correct operating system folder.

5.Click iCam Digital to install drivers. Once drivers are installed, restart the computer.

Figure 12. iCam Digital driver installer

6. Plug the USB cable into a USB port on the Mac.

FlexCam iCam Digital — Getting Started

Installing ArcSoft Software

To install ArcSoft Software on Windows

1.From My Computer, right-click the ArcSoft CD icon and select Explore.

2.Double-click Setup.exe.

3.Follow the on-screen prompts. Both programs are installed through the same installation wizard.

Figure 13. Installing the ArcSoft programs

4. Restart your computer.

To install ArcSoft Software on a Mac OS

1.Double-click the Video Impression 1.6 Installer icon (see Figure 11) and follow the on-screen prompts.

2.When Video Impression finishes installing, double-click the PhotoStudio Installer and follow the on-screen prompts.

3.Restart your computer.

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760