Setup Guide (cont.)
last two digits blinking (“20_ _”) (d). Again use the Up/Down buttons to change the |
| ||
year if necessary, press enter, and set the time (“TIME” will flash, press enter and use |
| ||
Up/Down to set the hour and minute. The time display uses the 24 hr standard, so 2:00 |
| ||
PM is indicated as “1400”, etc). | d | ||
4. After the date and time have been set, and Enter is pressed, “EVENT” will flash on | |||
| |||
the display. Press Enter and the “camera” icons for still photos and movie clips will both |
| ||
| |||
blink (e). Press Enter again, and only the still camera icon will blink. Pressing the UP or |
|
| |
DOWN buttons will now cycle between the 2 photo mode choices: Still Photos or Video |
| ||
Clips. This allows you to choose which type of file will be recorded every 30 seconds | e | ||
for as long as motion and heat events are detected. Select the photo mode you prefer and | |||
press ENTER while that icon is blinking. |
| ||
5.After selecting still photo or movie clip mode, press ENTER. Two options for still photo resolution, LO and HI will blink (f). Press ENTER again and use the UP or DOWN buttons to set the resolution. LO resolution (2MP on Standard model, 3MP on Night Vision models) will allow you to store more photos on the SD card before it is filled, and the quality is suitable for viewing on a PC monitor, email or web sites,
and making small prints. HI resolution (4MP on Standard model, 5MP on Night Vision | f | |
models) creates larger files via software interpolation, taking up more space on the card, | ||
| ||
but they are higher quality, better suited for printing enlargements or capturing more |
| |
| ||
detail. After setting the still photo resolution, press ENTER. |
|
6.(Night Vision models only) After selecting still photo or movie clip mode, press ENTER. The “Sun” icon will blink
119204+119305 Trail Sentry | 3/3/08 11:51:15 PM |