1.8Installation
To setup Avenview DVI-VIDEOWALL-9X follow the steps outlined below for connecting to a device.
1.Use the best quality DVI, VGA, Composite, S-Video cables.
2.Turn OFF DVI-VIDEOWALL-9X and all devices that are to be connected to it.
3.Connect 9 Monitors (or projectors, TV or other display devices) to DVI OUTPUT of DVI-VIDEOWALL-9X.
4.Connect the Source device (such as, PC, DVD Player, Media Player etc.) to DVI-VIDEOWALL-9X.
5.Connect a Windows based laptop or desktop (that will used to configure the DVI-VIDEOWALL-9X) to DVI-VIDEOWALL-9X by a –pm RS-232 to USB Adapter.
6.Power ON DVI-VIDEOWALL-9X.
7.Turn ON all devices connected to DVI-VIDEOWALL-9X and then setup the DVI-VIDEOWALL-9X from the system through RS-232 to USB Adapter and provided Avenview software.
DO NOT block the sides of this device or stack another device on the top or bottom of the DVI-VIDEOWALL-9X. If sides of the units are blocked it will block the air flow from the fans on the side of the unit. This could cause system to over-heat, which may result in system failure.
