Allied International GX1050C manual Gigabit Ethernet Ports, See Addendum for more detail

GIGABIT ETHERNET PORTS

These ports conform to the IEEE 802.3 1000BASE-T standard for Gigabit Ethernet over copper. It is recommended that CAT5E or CAT6 compatible cabling and connectors be used for best performance. Cable lengths up to 100m are supported. For higher bandwidth requirements, both ports can be used in a link aggregation group (LAG) configuration.

GENERAL PURPOSE IO PORT

PIN FUNCTION

1 POWER GROUND

2 EXTERNAL POWER

3 SYNC OUT 4

4 SYNC IN 1

5 SYNC OUT 3

6 SYNC OUT 1

7 USER GROUND

8 RS-232 RXD

9 RS-232 TXD

10 USER VCC

11 SYNC IN 2

12 SYNC OUT 2

GENERAL PURPOSE IO PORT AS SEEN FROM

BACK OF CAMERA

The General Purpose I/O port uses a Hirose HR10A-10R-12PB connector on the camera side. The mating cable connector is Hirose HR10A-10P-12S. This connector can be purchased from AVT Canada Inc. or from http://www.digikey.com. An open- ended cable assembly can also be ordered from AVT Canada Inc. (Part number 02- 6033A).

See Addendum for more detail.

POWER GROUND

This is the main ground of the camera circuitry and will be the return path for the external power source. This connection must be provided to operate the camera. The conductor used for this connection must be adequate for the current consumption of the camera. For best performance the connection for POWER GROUND should be physically close to the EXTERNAL POWER connection.

GX1050 Technical Manual Page 11