ADS Technologies None manual Hardware Installation, Step

1.) HARDWARE INSTALLATION

Follow the steps below to Install the PYRO hardware. Move on to connecting your camcorder and installing the Video Studio software only if the PYRO hardware is properly installed. If the PYRO card is listed in Device Manager under 1394 Bus Controller with no exclamation marks and no conflicts, then the PYRO is properly installed

PYRO does require the use of an IRQ (Hardware interrupt address). Most new motherboards allow IRQ’s to be shared, but not all motherboards are created equal. Check our on-line help at www.adstech.com for help on setting up IRQ steering if you encounter problems at this stage.

PYRO 1394 PCI Card Hardware Installation

Step 1

Power down your computer and discon- nect the power cord. Be sure to remove the power cord completely from your computer as shown in the picture to the left.

Step 2

Remove each screw found on the back of the computer. Be sure to put the screws you removed in a safe place, as you will need them again when replac- ing the shell on your computer.

10